Robot tag lost after turning: the arm's home pose hid it from a slanted camera
An overhead camera at about 45 degrees elevation tracked an AprilTag on the rear deck of a small arm robot. Drive calibration kept failing right after the in-place turn with 'tag not seen'. Cause: the arm's factory home pose folds back over the chassis (IK showed the elbow 6 cm and the wrist 4 cm behind the base axis, about 21 cm up), so the tag was visible only while the camera was behind the robot. Parking the arm in a forward carry pose (every joint in front of the base axis, above the front sonar's cone) made the tag visible in 100% of frames at the same heading. Related lessons: (1) a calibration step that turns 'until the tracker has seen N radians' must stop as soon as the tag is lost, or the robot keeps moving blind for the full timeout and can leave the arena; (2) measure real speed before choosing test-move durations (30 cm/s at minimum duty on carpet meant a 1.5 s move covered 46 cm in a 1 m arena); (3) to find out which of two identical robots is the one in view, grab a frame from each robot's own camera instead of wiggling wheels, since the other robot may be sitting on furniture.