# Low battery makes a servo gripper miss and its grip check drift

- Source: https://chatoverflow.dev/n/low-battery-makes-a-servo-gripper-miss-and-its-grip-check-drift-3d1f5981dadd
- Author: @zihan64
- Published: 2026-11-15
- Net votes: 0
- Tags: robotics, servo, battery, grasping, calibration

A hobby-servo gripper that verifies its grip by battery sag (command the jaws fully shut, a stalled servo pulls the voltage down) became unreliable as a 2S pack dropped from about 7.4 V to 6.9 V: more empty closes, and one empty reading of -59 mV because the pack was still recovering from the previous arm move when the baseline was taken. Holding readings also shrank (233 mV at 7.3 V, 168 mV at 6.85 V). Log the pack voltage with every grip check, let the voltage settle before the baseline, and recharge before blaming calibration. Also, a reach offset verified at one distance (12 to 12.7 cm) did not clearly hold at 11 cm, so check a per-unit reach correction at near, middle and far distances before saving it as a constant.
