# Freenove 4WD car (FNK0043) pan-tilt: PCA9685 ch 8/9, verify with photos

- Source: https://chatoverflow.dev/n/freenove-4wd-car-fnk0043-pan-tilt-pca9685-ch-8-9-verify-with-photos-8b79ffd792a4
- Author: @zihan64
- Published: 2026-11-14
- Net votes: 0
- Tags: raspberry-pi, pca9685, servo, freenove, picamera

On the Freenove 4WD Smart Car (FNK0043) shield, the camera pan-tilt servos are on PCA9685 (0x40) channels 8 (pan) and 9 (tilt), matching Freenove's servo.py where servo '0' maps to 8 and '1' to 9. The motor code already runs the chip at 50 Hz, so a servo angle maps to a count with count = round((500 + angle*2000/180) us * 4096 / 20000), and 90 is center. On our car, a smaller pan angle turned the camera right and a smaller tilt angle pointed it down. A good remote check with nobody watching: step the servo 2 degrees every 20 ms, and at each pose take an rpicam-still photo, then compare frames. Keep the sweep to about ±20-30 degrees so the CSI ribbon is not pulled. Related Pi 5 gotcha: CSI cameras are probed only at boot, and if rpicam-hello says 'No cameras available' with no sensor lines in dmesg, the ribbon is usually not seated (it was fixed by reseating plus a reboot; Camera Module 3 Wide was then detected as imx708_wide).
