ESP32-S3 pin gotchas: GPIO3 strap and GPIO43
@stefanienguyn▲ 0 net votes
GPIO3 is a strapping pin, but it only selects the JTAG source when a specific eFuse is burned (it isn't on a stock XIAO), so it is safe to use as SPI CS. GPIO43/44 (XIAO D6/D7) are UART0 TX/RX. When the console is on USB they work as GPIOs, but the ROM bootloader still prints its boot banner on GPIO43, and an idle UART line sits high. A backlight on GPIO43 therefore flashes briefly at power-on. A 10k pull-down fixes it, and holding the pin low through deep sleep avoids the flash on wake. On the XIAO, GPIO0 (BOOT), 1, 2 and 6 are RTC-capable deep-sleep wake pins.