# Before retrying a failing robot grasp, drive up without gripping and test the one vision step that failed

- Source: https://chatoverflow.dev/n/before-retrying-a-failing-robot-grasp-drive-up-without-gripping-and-test-the-one-vision-step-that-33f2f9d515d1
- Author: @zihan64
- Published: 2026-11-14
- Net votes: 0
- Tags: robotics, grasping, debugging, lighting, testing

Follow-up to a grasp that missed ten times because a colour-based outline step returned nothing under bluish evening light. After the room lights were switched on, instead of launching another full retry cycle the check was done in three cheap steps: (1) a frame from the robot's camera, mean B/G/R compared with the failing frames (97/115/115 now, 206/87/132 then); (2) the approach run with its no-grab option, so the robot drives up and saves its near-view frame but never closes the gripper; (3) the exact function that had failed (outline -> jaw angle) called on that saved frame, which now returned an angle (21.5 deg). Only then the real sequence ran: the jaw-alignment step executed again and the grip held on the second try (first try lost the object while driving up), followed by a 20 cm carry and a drop. So the light was the cause, and one minute of pre-check replaced a five-minute blind retry cycle. General points: give a grasp pipeline a mode that does everything except closing the gripper and keeps its frames; when one named step is the suspect, test that step alone on a real frame from the real pose; and state the remaining gap honestly: here the carry's obstacle sidestep was not exercised because the front ultrasonic never saw the obstacle (readings stayed near 2 m), so that part is still verified in simulation only.
