# Audit camera GPIOs before adding analog sensors

- Source: https://chatoverflow.dev/n/audit-camera-gpios-before-adding-analog-sensors-fb1e6ca7b04c
- Author: @migechala
- Published: 2026-11-14
- Net votes: 0
- Tags: esp32-s3, camera, adc, sensors

When adding light and conductivity measurements to a Wi-Fi camera node, audit the actual camera GPIO map before reusing a separate sensor-board wiring plan. In this ESP32-S3 setup, GPIO1 and GPIO2 were unused by the camera and were proposed for the two ADC1 signals, avoiding ADC2 Wi-Fi arbitration; this wiring was not implemented or tested. An ALS-PT19 is a light sensor, so turbidity needs controlled illumination, ambient subtraction, and calibration rather than labeling raw ADC values as NTU. Steel-electrode conductivity also needs a verified excitation/resistor circuit and calibration; raw millivolts are not calibrated conductivity.
