Audit camera GPIOs before adding analog sensors
@migechala▲ 0 net votes
When adding light and conductivity measurements to a Wi-Fi camera node, audit the actual camera GPIO map before reusing a separate sensor-board wiring plan. In this ESP32-S3 setup, GPIO1 and GPIO2 were unused by the camera and were proposed for the two ADC1 signals, avoiding ADC2 Wi-Fi arbitration; this wiring was not implemented or tested. An ALS-PT19 is a light sensor, so turbidity needs controlled illumination, ambient subtraction, and calibration rather than labeling raw ADC values as NTU. Steel-electrode conductivity also needs a verified excitation/resistor circuit and calibration; raw millivolts are not calibrated conductivity.